Manitowoc-ice J-0600 Instrukcja Użytkownika Pobierz pdf

J/B/G-0600 COMPRESSOR REPLACEMENT

Installation Instructions

NOTE: THIS REPLACEMENT IS ONLY FOR THE J, B, AND G-SERIES ICE MACHINES. START AND RUN

COMPONENT CHANGES VARY WITH THE TYPE OF MACHINE. FOR J-SERIES MACHINES ONLY, THE

RUN CAPACITOR NEEDS TO BE REPLACED WITH THE ONE INCLUDED IN THE KIT. B AND G-SERIES

MACHINES NEED ALL OF THE START AND RUN COMPONENTS REPLACED WITH THE ONES

INCLUDED IN THE KIT.

1. Disconnect power to the ice machine at the electrical

disconnect (moving the toggle switch to the off

position will not disconnect line voltage).

2. Remove panels (top, front, left and right sides).

3. Recover refrigerant from ice machine.

4. Remove right side corner post (when facing the front

of the machine) and back panel.

5. Remove wiring from compressor terminals.

6. Unsweat suction line at compressor port. Unsweat

discharge and process lines at the T fitting and

swage joint (or after “T” fitting, if remote)

respectively.

NOTE: IF REPLACING COMPRESSOR IN A

REMOTE ICE MACHINE, BE SURE TO

UNSWEAT THE CONNECTION BETWEEN

THE HPR VALVE AND THE PROCESS

TUBING AT THE “T” FITTING.

7. Remove compressor from machine. Make sure to

crimp and braze shut ports to compressor.

8. Insert new compressor into the machine, as shown.

Manitowoc Ice, Inc.

2110 South 26 Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA 8006183

Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879 Sheet 1 of 3

Web Site - www.manitowocice.com 06/25/01

“T” Fitting

Swage Joint

1 2 3

Strona 1

J/B/G-0600 COMPRESSOR REPLACEMENT Installation Instructions NOTE: THIS REP

9. Fit tubing provided into the proper place, as shown. Cut ice machine suction line to fit new tubing. Deburr suction line before fitting new tu

17. Make sure that all the tubing is not rubbing against anything else in the machine. 18. Reinstall the corner post that was removed earlier and

Brak uwag

Manitowoc-ice J-0600 Instrukcja Użytkownika